IT IS REQUIRED THAT ALL ECU’S / MODULES BEING SHIPPED TO US HAVE TRACKING INFORMATION SENT TO US IN-ADVANCE (info@m-engineering.us). PLEASE ALSO INCLUDE A NOTE WITH YOUR DETAILED VEHICLE INFORMATION AND RETURN SHIPPING ADDRESS / CONTACT INFO. FAILURE TO DO SO WILL CAUSE A DELAY IN RETURN SHIPPING.

https://youtu.be/Ricuj_y9iIk?si=U8U2sE0llMBMa-nl

...

Tools Needed

• Masking Tape

• Ratchet

• T25 Torx Bit (some models have a T30 Torx Bitinstead)

• 16mm socket
  

  

Instructions

Step 1: Working Space and Protection

...

The PDK2 module is located on the driver (left hand) side under the carpet. You will need to simply pull away the carpet to view the module. There are 3x T30 Torx bolts holding down the module. Remove these three bolts and then you can move the module in a position to where you can unplug the harness.

The PDK2 module has a plastic case that you can remove easily. Please remove this before shipping. DO NOT SHIP THE PLASTIC PDK2 BRACKET TO US, REMOVE IT.

...

Step 6: Mail us the PDK Module

Send us the PDK Module. MAKE SURE TO INCLUDE YOUR CONTACT INFORMATION AND RETURN ADDRESS AS WELL AS ANY NOTES FOR US. We will need to know things like your mods/mapping you are running on the car. Payment must be made before we can send the PDK2 module back to you. We always use next-day air return shipping in the lower 48 unless otherwise noted. DO NOT SHIP THE PLASTIC BRACKET.

Send the PDK2 to this address:

M-ENGINEERING
3460 NW 27th Avenue
Unit D7
Pompano Beach, FL 33069

...