Table of Contents | ||
---|---|---|
|
Stage Hardware Requirements
Stage1 - Designed for a vehicle with the following modifications:
headers: Stock
Exhaust: Stock
Air Filter: Stock or aftermarket drop-in filters
Fuel System: Stock
Stage2 - Designed for a vehicle with the following modifications:
Headers: Stock
Exhaust: Aftermarket
Air Filter: Stock or aftermarket drop-in filters
Fuel System: Stock
Minimum Octane Requirements
91 Octane - For use with 91 octane (R+M)/2 or 95RON fuels minimum. 94 octane fuels with 0% Ethanol should also run the 91 octane file.
93 Octane - For use with 93 octane (R+M)/2 or 98RON fuels minimum.
*Warning*
Using a lower octane than is designated by the calibration can promote increased engine wear and in severe cases catastrophic engine damage. Never run a map designed for high octane with low octane in the fuel tank. E.g. Do not run the 100 Octane map with 93 octane fuel in the tank.
Torque and Horsepower Output
These dyno charts represent typical power output to the wheels as tested on a Mustang dynomometer.
“Max Gain” represents the largest delta between any two points on the graph at the same RPM.
“Peak Gain” represents the overall delta of the highest reading per dyno plot.
We break up power gains into % and numerical gains. We know that every dyno reads a bit different, particularly between manufacturers, so we have utilized the percentage gains which should be similar and independent of the dyno. The numerical delta gains are a more user friendly value but may not read similar on every dyno.
Stage1
91 Octane (R+M)/2 or 95 RON
93 Octane (R+M)/2 or 98 RON
If your parts configuration or octane fall outside of the bounds of these maps we do offer ProTuning services past what is offered here in the maps.
Custom Features
Map Switching and M-Logger are only available through M-Engineering or our authorized dealers. These features all require custom code that has been written in house by our staff of reverse/software engineers.
Feature
Description
M-Logger
A feature in the M-Tuner Suite that allows end users to data log up to 75 parameters at speeds of up to 120Hz. The parameters logged are vital to proper engine health and function. Different parameters can be logged depending on situations based on logging profiles. This is particularly useful when diagnosing a mechanical issue with the car or revising a calibration to optimize it for your parts configuration if it lies outside of our standard off the shelf type recommendations.
Left Foot Braking
.
Contact Info
If you have any further questions please feel free to contact us via email.
Info@M-Engineering.us